VMAC’s Hydraulic Driven air compressor is the best choice for customers looking for a compact, powerful and lightweight hydraulic deck-mount air compressor that can operate in any climate.
Hydraulic Driven Air Compressors—the smartest, smallest and most powerful hydraulic air compressor available!
Air receiver tanks are used for lowering compressor duty cycle and removing water from compressed air. Recommended for proper operation of all VMAC Hydraulic air compressor functions, including Standby Mode; manufactured to FMVSS 121 Standard; includes fittings, 160psi pressure relief valve, and tank drain. Maximum pressure: Up to 150 psi.
Air receiver tanks are used for lowering compressor duty cycle and removing water from compressed air. Recommended for optimum operation of VMAC Hydraulic Air Compressors, VMAC Diesel Driven Air Compressors, UNDERHOOD40, UNDERHOOD70 (including Green Series Air Compressors), DTM70/DTM70-H, and VMAC Multifunction Power Systems, which include standby mode; ASME certified.
Air receiver tanks are used for lowering compressor duty cycle and removing water from compressed air. Recommended for optimum operation of VMAC Diesel Air Compressors, Hydraulic Air Compressors, UNDERHOOD40, UNDERHOOD70 (including Green Series Air Compressors), DTM70/DTM70-H, and VMAC Multifunction Power Systems, which include standby mode; ASME certified; includes fittings.
Extends life of air tools; filter removes contaminants from the compressed air, adjustable regulator can reduce air pressure going to tools, and lubricator adds atomized tool oil to the air stream to lubricate air tools. Maximum flow: Up to 70 CFM / 150 psi Port size: 3/4" NPT inlet.
Improves performance and extends life of air tools; removes up to 80% of water from compressed air; includes automatic water drain. Maximum flow: 70 CFM / 175 psi Port size: 3/4" NPT inlet and outlet Electrical: 12 V Dimensions: 17.0” (l) x 8.0” (w) x 14.5” (h); 43.2 cm
Used for an easier and more rigid install, for mounting on thinner gauge service bodies; allows more airflow around the air compressor.
Converts 24 V power to 12 V, to allow the air compressor to be used on a 24 V electrical system.
Fully automated manifold heater block; recommended for extreme cold climates; when hydraulic oil temperatures fall below 5°F (-15°C), a solenoid will energize and heat the hydraulic oil.
VMAC’s Throttle Commander high idle electronic throttle controls speed up your truck’s engine when the vehicle is stationary. With the vehicle’s engine at high idle, more power is available for heavy alternator loads, cooling systems and Power Take-off (PTO) applications. This means jobs get done faster, saving time and money.
Recommended for high duty cycle industrial and work truck hydraulic systems working in extreme hot climates, 100°F (37°C) and above; capable of removing up to 33,750 BTU / Hr. Hydraulic flow: 5-20 GPM (19-76 LPM) Pressure rating: Up to 500 psi (34.5 bar) Electrical: 12 V @ 10 Amps.
Spring-loaded 1/2" x 50’ hose reel; steel construction; full flow shaft and swivel for maximum performance. Maximum pressure: 300 psi Dimensions: 19.0” (l) x 7.0” (w) x 20.25” (h); 48.3 cm (l) x 17.8 cm (w) x 51.4 cm (h) Weight: 51 lbs (23.1 kg)